Asphalt Cutback with Agricultural Oil Material

image

RACT for the Use of Cutback Asphalts in Road Construction ...

EPA-340/1-80-015 RACT for the Use of Cutback Asphalts In Road Construction and Maintenance: Enforcement Implications and Equipment Changes by Robert W. Elfstrom, Jr. and Robert W. Schlosser JACA Corp. 550 Pinetown Road Fort Washington, PA 19034 Contract No. 68-01 -4135 Task No. 48 EPA Project Officer: Robert L. King Prepared for U.S. ENVIRONMENTAL PROTECTION …

Contact Supplier
image

CHAPTER 4 BITUMEN BOUND PAVEMENT MATERIALS

4. Bitumen Bound Pavement Materials Cutback Bitumens Medium-Curing (MC) Cutbacks: produced by fluxing, or cutting back, the residual asphalt (usually 120-150 penetration) with light fuel oil or kerosene. The term medium refers to the medium volatility of the kerosene-type dilutent used.

Contact Supplier
image

MATERIAL SAFETY DATA SHEET Section 1: Product and …

Land Spill : Solidify with sand, oil dry or other absorbent material, pick up and put into suitable container for disposal as a non-hazardous waste. Check with local landfills ... cutback asphalt) as possibly carcinogenic to humans (Group 2B). This cl assification was

Contact Supplier
image

ASTM D 3143 98 Flash Point of Cutback Asphalt with Tag ...

Asphalt Cutback with Agricultural Oil Material Safety Cutback with Agricultural Oil Material Safety Data Sheet ... Asphalt Cutback w/ Veg. Oil Technical ... Do not allow liquid runoff to enter sewers or public ... ASTM D 5059 - 98. ASTM D 994 - 98.

Contact Supplier
image

MATERIAL SAFETY DATA SHEET MSDS: 951 Asphalt …

MATERIAL SAFETY DATA SHEET MSDS: 951 Asphalt Emulsions REVISION: 1 REVISION DATE: 09/03/09 SECTION 1: PRODUCT AND COMPANY IDENTIFICATION ... This Material Safety Data Sheet applies to the listed products and synonym descriptions for Hazard ... U. S. OIL & REFINING CO. ADDRESS: 3001 Marshall Ave., Tacoma, WA 98421 ...

Contact Supplier
image

Cutback Asphalt Emulsion -vs-

Cutback Asphalt Asphalt Emulsion-vs-Figure 4.1. Comparison of the residual asphalt content of different binders. ... material passing all of the slots is then divided by the total weight of the sample to give the percent flat particles, by weight, or Flakiness Index.

Contact Supplier
image

Asphalt Seal-Coat Treatments - US Forest Service

Asphalt Seal-Coat Treatments Asphalt Seal-Coat Treatments. Alan Yamada; Civil Engineer; Project Leader ... or heavy oil. After the liquid material is applied to the road surface, the solvent evaporates, leaving the asphalt cement on the roadway. ... is usually applied as a hot asphalt cement, cutback asphalt, or emulsified asphalt. After the ...

Contact Supplier
image

Field Manufacture of Asphalt Cutbacks

the field manufacture of asphalt cutbacks.) Table 5-1. Equipment Used to Manufacture Asphalt Cutback Equipment Function Hot-oil heater Used to heat bitumen. Asphalt pumps One asphalt pump is a portable pumping unit that transfers bituminous material from heating facilities to a storage tank, and another pump transfers the cutter stock to the ...

Contact Supplier
image

Tack Coat Guidelines 1-09 - Caltrans

 · Tack Coat Guidelines STATE OF CALIFORNIA DEPARTMENT OF TRANSPORTATION Division of Construction ... The principal source of asphalt binders is the refining of crude oil. Asphalt binders must ... coat material used and the hot mix asphalt that will be placed as an overlay. Dense and

Contact Supplier
image

How asphalt cement is made - material, used, processing ...

Asphalt paving material is a dull black mixture of asphalt cement, sand, and crushed rock. ... liquid bitumen. Asphalt is a natural constituent of petroleum, and there are crude oils which are almost entirely asphalt. Oil wells supply the crude petroleum to the oil refineries, where it is separated into its various components or fractions ...

Contact Supplier
image

Specifications For CUTBACK ASPHALT Manufactured Materials ...

The MC Cutback Asphalt is a mixture of an asphalt cement, with a kerosene type of solvent. If the supplier elects to use non traditional material components in the MC Cutback

Contact Supplier
image

Safety Data Sheet | E&B Paving

Marathon PG Asphalt Binder, all grades: 1/24/2012: Medium Cure Asphalt- Marathon: 5/19/2015: Paving and Emulsion Base Asphalt: 02/25/2011 11:47:57: Permacoat 250 Slowcure cutback asphalt – coldmix: 02/25/2011 11:47:58: Petroleum Asphalt- Marathon: 07/6/2015: Petroleum Hydrocarbon Mixture: 7/21/2015: Road Oil Asphalt- Marathon: 5/19/2015: Safe ...

Contact Supplier
image

ASPHALT HAZARD SUMMARY HOW TO DETERMINE IF …

glove/clothing material for your operation. * All protective clothing (suits, gloves, footwear, headgear) should be clean, available each day, and put on before ... prohibited where Cutback and Rapid Curing Asphalt are used, handled, or stored. * Metal containers involving the transfer of Cutback and

Contact Supplier
image

Asphalt Cutback, Asphalt Cutback Suppliers and ...

There are 59,544 asphalt cutback suppliers, mainly located in Asia. The top supplying countries are China (Mainland), India, and United Arab Emirates, which supply 94%, 1%, and 1% of asphalt cutback respectively. Asphalt cutback products are most popular …

Contact Supplier
image

Specifications For CUTBACK ASPHALT Manufactured …

- Principal Uses of Asphalt Materials of the National Standard of Canada CAN/CGSB-16.6-M89, PRINCIPAL USES AND TERMINOLOGY FOR ASPHALT MATERIALS FOR ROAD PURPOSES. 1.4 Method of Production SC Cutback Asphalt is a mixture of an asphalt cement and diesel type solvents or a direct product of the refining process using residual oily asphalts.

Contact Supplier
image

Pavement materials: Bitumen - IIT Bombay

The consistency of asphalt cement from this process can be controlled by the amount of heavy gas oil removed. Normally, asphalt produced by this process is softer. As the asphalt cools down to room temperature, it becomes a semi solid viscous material. Different forms of bitumen Cutback bitumen Normal practice is to heat bitumen to reduce its ...

Contact Supplier
image

Asphalt, Bitumen and Tar – Types, Difference and Comparison

Difference between Asphalt, bitumen and tar, their types and comparisons of their properties is discussed. Asphalt, bitumen and tar have similar properties generally used for pavements Construction. The asphalt is a mixture which consists alumina, lime, silica and asphaltic bitumen. At low ...

Contact Supplier
image

SAFETY DATA SHEET - Valero

SAFETY DATA SHEET 1. Identification Product identifier MC Cutback Asphalt Other means of identification SDS number 211-GHS Synonyms MC-30, MC-70, MC-250, MC-800, MC-3000, Medium Cure Asphalt, Cutback Asphalt, Road Asphalt, Road Oil See section 16 for complete information.

Contact Supplier
image

Coal Tar Sealer Vs. Asphalt Cutbacks - What is best, and ...

Coal Tar Sealer Vs. Asphalt Cutbacks – What is best, and when to use? ... Refined coal tar emulsion gives the unsurpassed wear characteristics and protects the pavement from motor oil, gasoline and other petroleum products. ... of cutback asphalt has largely been eliminated in New York State with the widespread availability of low VOC ...

Contact Supplier
image

Asphalt Materials, Emuliscoat and Bituminous Materials ...

Search Products: Select Chip Seal Fog Seal Microsurfacing Spray Patch Dust Control Crack Filling Hot Mix Asphalt Cold Patch Mix Cold Constructed Asphalt Pavements Full Depth Reclamation Tack Coat and Prime Coat Polymer Modified Asphalts

Contact Supplier
image

RACT for the Use of Cutback Asphalts in Road Construction ...

EPA-340/1-80-015 RACT for the Use of Cutback Asphalts In Road Construction and Maintenance: Enforcement Implications and Equipment Changes by Robert W. Elfstrom, Jr. and Robert W. Schlosser JACA Corp. 550 Pinetown Road Fort Washington, PA 19034 Contract No. 68-01 -4135 Task No. 48 EPA Project Officer: Robert L. King Prepared for U.S. ENVIRONMENTAL PROTECTION …

Contact Supplier
image

Slow Curing Cutbacks | McAsphalt

Home » MCA Products » Asphalt Cutbacks » Slow Curing Cutbacks. ... diluents or cutter stock. If the solvent used in making the cutback asphalt is highly volatile, it will quickly escape by evaporation. Solvents of lower volatility evaporate more slowly. ... This term originated in earlier days when asphalt residual oil was used to give roads ...

Contact Supplier
image

MATERIAL SAFETY DATA SHEET - Vance Brothers

MATERIAL SAFETY DATA SHEET 5201 Brighton, P.O. Box 300107 Kansas City, MO 64130 Phone: 816-923-4325/ 800-821-8549 FAX: 816-923-6472 Emergency Phone Number (CHEMTREC): 800-424-9300 I. PRODUCT INFORMATION TRADE NAME MC-250, MC-800, MC-3000 C.A.S. NUMBER Mixture SYNONYMS Cutback Asphalt, Road Oil, Prime Oil PRODUCT CODE NUMBER 102, 103, 104, 111 ...

Contact Supplier
image

Power Asphalt Sprayers – Marathon Equipment

115 gal Power Asphalt Sprayer – Skid Mounted Marathon's 115 gallon skid mounted sealer sprayer was developed with affordability in mind. This non-heated unit was designed for use with driveway sealer material such as Gilsonite, asphalt cutback, solvent based …

Contact Supplier
image

Cutback Bitumen - Bitumina | A Global Bitumen Company

What is Bitumen (Asphalt) Cutback Bitumen? ... Cutback bitumens suitable for priming are also used for tack coats, which are applied to an underlying surface to help with the adhesion of subsequent asphalt layer. A typical application rate is between 0.2 and 0.4 L/m2. ... Bitumina Refined Oil Products.

Contact Supplier
image

Emulsified Asphalt

Emulsified Asphalt. Emulsified Asphalt (also simply called emulsion) is a mixture of asphalt cement, water and an emulsifying agent. Emulsion is made by combining these materials and passing them through a mill. Emulsions are liquid at ambient temperatures. They can be applied at cooler temperatures than asphalt cements and cutback asphalts.

Contact Supplier
image

Emulsified Asphalt

Emulsified Asphalt. Emulsified Asphalt (also simply called emulsion) is a mixture of asphalt cement, water and an emulsifying agent. Emulsion is made by combining these materials and passing them through a mill. Emulsions are liquid at ambient temperatures. They can be applied at cooler temperatures than asphalt cements and cutback asphalts.

Contact Supplier
image

Medium Curing Cutbacks | McAsphalt

Home » MCA Products » Asphalt Cutbacks » Medium Curing Cutbacks. Medium Curing Cutbacks. ... diluents or cutter stock. If the solvent used in making the cutback asphalt is highly volatile, it will quickly escape by evaporation. Solvents of lower volatility evaporate more slowly. On the basis of the relative speed of evaporation, cutback ...

Contact Supplier
image

Construction Division Materials and Pavements Section

Construction Division Materials and Pavements Section . Last updated November 2015. ... medium-setting, high-viscosity emulsion with some added fuel oil for increased stockpile life (used for patching mixes). ... between anionic and cationic emulsions, and how the chemistry affects the break and cure, refer to Asphalt Emulsion. Cutback Asphalt ...

Contact Supplier
image

MARKET OPPORTUNITY SUMMARY SOY-BASED ASPHALT …

Petroleum solvent use in cutback asphalt in 2005 was 256 million pounds. 2. Foamed Asphalt – 10 percent of market. ... petroleum oil seal products. ACTIVATE™ – Asphalt millings (RAP-reclaimed asphalt pavement) restorer. ... Agricultural Marketing Service has oversight responsibilities for USB and the soy checkoff.

Contact Supplier
image

Asphalt Materials List - Asphalt Maintenance Equipment

Asphalt Materials List ... Also used as a tack oil before asphalt patching. Material is not pliable and reflective cracking will happen in cold temperatures Cutback Asphalts-For tack coating and chip sealing operations. Highly flammable operator needs training on materials before use. Cutback oils are AC+naptha to thin product.

Contact Supplier
image

MC-30, MC-70, MC-250, MC-800, MC-3000

Contact with hot cutback asphalt can cause thermal burns to the eyes. Prolonged exposure to vapors, fumes, or mists may cause irritation, redness, and tearing. Skin Hazards Contact with hot cutback asphalt can cause thermal burns. Prolonged exposure to vapors, fumes, or …

Contact Supplier
image

ITEM 300 ASPHALTS, OILS AND EMULSIONS 300.2. …

ITEM 300 ASPHALTS, OILS AND EMULSIONS 300.1. Description. This Item shall govern for asphalt cement, cutback asphalts, emulsified asphalts, other miscellaneous asphaltic materials and latex additives. ... Oil Distillate, % by volume of emulsion 65 - - 1/2 65 - - 1/2 65 - ...

Contact Supplier

ONLINE CHAT

Copyright © . All rights reserved. sitemap